Welcome to Hanzhu's Blog

 Cement/concrete pouring mould Remove the mold final photos

 Make mould Since the chair wanted to recreate the texture of the surrounding environment, we made the pattern with cardboard and cardboard and pasted it into the inside of the chair At the beginning of the model making, we considered making a hollow model, so we made the internal model

 In this group, the chair I was assigned was beautiful in appearance but very difficult. Every Angle of the chair was a special Angle, instead of 90 or 30 degrees, which were easy to make. It needed very precise measurement to draw the mold. Our team made a 3D model of the model to study how much cement was needed to make the chair. When calculating the amount of cement, our team considered making the chair a hollow chair without changing its appearance, but without making it solid in the middle. We used mathematical methods to measure and calculate each piece of mold, and finally rounded to get an Angle data after one decimal point for model making.

 In the end, we use leather to make the final product. Textile is used to connect each piece of leather and heating plate. Finally, buttons are used to fix each piece. A charging bank (55V) is used as the power supply of the chip. final sample As for the circuit connection, we consider using the chip to connect the heating plate, and make the chip emit heartbeat sound, and flash red light with each heartbeat sound vibration. How to hide the line in our product by using the bench to install and test the line final photos